Model Name	TEAC TN-3B
Turntable section
Type	Belt-drive (External drive)
Motor	DC Motor
Rotation Speeds	33-⅓ rpm, 45 rpm
Wow-and-Flutters	0.1% or less
S/N Ratio	67dB (A-weighted, 20kHz LPF)
Turntable (Platter)
Material	Aluminum Die-cast
Diameter	30cm
Tone-arm section
Type	S-shape, Static-balanced
Effective Length	223mm
Needle Pressure Range	0g to 5.0g
Compatible Cartridge Weight	3.0g to 12.0g 14g to 23g (including Head-shell)
Cartridge section
Type	MM-type
Output Voltage	4.0mV (1kHz, 5cm/sec.)
Needle Pressure	1.8 to 2.2g (2.0g recommended)
Weight	6.1g
Head-shell weight	11g (including screws, nuts, and wires)
Compatible Stylus	AT-VMN95E * Average stylus life: approx. 300 hours.
Analog Outputs
Connector	RCA Pin jack × 1 pair (Gold-plated)
Output Voltage
PHONO	4.0mV (1kHz)
LINE	224mV (–13dBV)
USB Output
Connector	USB B-type (DC 5V 100mA USB Bus power required)
Audio Format	PCM, 8k/11.025k/16k/22.5k/32k/44.1k/48kHz, 16bit
Operating Power	AC 100 to 240V, 50/60Hz
Power Consumption	1.5W
Standby Power	0.5W
Overall Dimensions (W×H×D)	420 × 117 × 356 mm / 16.5" × 4.6" × 14.0" (including protrusions)
Weight	approx. 5.0kg / 11.0 lbs.
Included Accessories	Felt Mat, EP Adapter, Counter Weight, Head-shell (AT-VM95E installed), Platter, Dust Cover, Hinges × 2, RCA Audio cable with GND terminal, AC Adapter (GPE053A-V120050), Owner's Manual (including Warranty Card)

Model Name	TEAC TN-400BT-SE
Turntable section
Type	Belt Drive
Motor	DC Motor
Rotation Speeds	33-⅓, 45, 78 rpm
Wow-and-Flutters	0.2%
S/N Ratio	more than 67dB (A-weighted) 60dB (unweighted, 20kHz, LPF)
Turntable (Platter)
Material	Aluminum Die-cast
Diameter	30cm
Tone-arm section
Type	S-shaped, Static-balanced
Effective Length	223mm
Needle Pressure Range	0g to 5g
Compatible Cartridge Weight	4g to 8g 14g to 18g (including Head-shell)
Head-shell and Cartridge sections
Model of Cartridge	audio-technica AT95E
Type of Cartridge	MM-type (VM-type)
Frequency Response	20Hz to 20,000Hz
Output Voltage	3.5mV (1kHz, 5cm/sec.)
Channel Separation	20dB (1kHz)
Output Balance	2.0 dB (1kHz)
Needle Pressure	1.5g to 2.5g (appropriate value: 2.0g)
Needle Life	approx. 300 hours (depends on conditions)
Coil Impedance	2.8kohms (1kHz)
DC Resistance	410ohms
Loading Resistance	47kohms
Loading Capacity	100 to 200pF
Coil Inductance	400mH (1kHz)
Static Compliance	20 × 10-6cm/dyne
Dynamic Compliance	6.5 × 10-6cm/dyne (100Hz)
Needle Shape	Joint-oval 0.3 × 0.7mil
Cantilever	Aluminum Pipe
Vertical Tracking Degree	20 degrees
Overall Dimensions	17.0(W) × 17.2(H) × 30.5(D) mm
Weight	5.7 g
Head-shell Weight	10g (including nuts, screws, and wires)
Analog Output section
Connectors	RCA jack × 1 pair (Gold-plated)
Output Voltage
PHONO	3.5mV +/-3dB
LINE	155mV (-16dBV)
Bluetooth® section
Bluetooth version	4.0 (DUAL MODE)
Output class	Class 2
Codecs	SBC, AAC, Qualcomm® aptX™
Maximum number of stored pairings	8 devices
Operation Power
AC Adapter Input	AC 100 - 240V, 50/60Hz
AC Adapter Output	DC 12V 500mA
Power Consumption	1.5W or less
Standby Power	0.5W or less
Dimensions (including protrusions)	420(W) × 117(H) × 356(D) mm / 16.5"(W) × 4.6"(H) × 14.0"(D)
Weight	4.9kg / 10.8lbs
Operating temperature range	5°C to 35°C
Included Accessories	Felt Mat, EP Adapter, Counter Weight, Headshell (audio-technica AT95E installed), Platter, Dust Cover, Dust Cover Hinges × 2, RCA Audio Cable with GND wiring, AC Adapter (GPE053A-V120050-Z), Owner's Manual (including Warranty Card)

Turntable section
Motor	DC Motor
Speed	33 1/3 RPM, 45 RPM RPM
Wow and Flutter	0.2%
Signal-to-Noise Ratio	67dB or higher (A-weighted, 20kHz LPF) 60dB (unweighted, 20kHz, LPF)
Platter	Aluminum Die-cast
Diameter of Platter	12", 30cm
Tonearm section
Type	Static Balance, Straight
Effective Arm Length	8.8", 223mm
Stylus Pressure Range	0 to 5g
Compatible Cartridge Range	3.5 to 6.5g
Anti-skating Adjustment	Supported
Cartridge section
Type	VM-type
Stylus Shape	Conical
Frequency Response	20Hz to 20kHz
Channel Separation	24dB at 1kHz, 15dB at 10kHz
Channel Balance	1.5dB
Tracking Forcee	3.5g±0.5 g
Output Impedance	47k ohms
Output Voltage	3.5mV
Cartridge Weight	5.0g±0.3 g
Head-shell Weight	10g (including nuts, screws and wires)
Stylus Replacement	audio-technica ATN3600L
Analog Output section
Connectors	RCA Pin x 1 pair (Chrome-plated)
Output Voltage
PHONO	4.2mV
LINE	120mV (–13dBV)
Bluetooth® section
Range	Approx. 30ft. / 10 meters
Supported Codec	SBC
General
Power	AC 100 to 240V, 50/60Hz
Power Consumption	< 1.5W (< 0.5W at Standby)
Overall Dimensions (W x H x D)	16.5" x 4.6" x 14.0" 420 x 117 x 356 mm
Weight	Approx. 10.8 lbs. 4.9 kg
Accessories	Rubber Sheet, EP Adapter, Counter Weight, Head-shell (MM-type Cartridge audio-technica AT3600L installed), Turntable (Platter), Dust Cover, Rubber Feet fro Dust Cover x2, Hinge x2, RCA Audio Cable, AC Adapter (GPE053A-120050-Z), Owner's Manual (including Warranty Card)

Turntable section
Drive System	Belt Drive
Motor	DC Motor
Speed	33-⅓ rpm, 45 rpm
Wow and Flutter	0.2% or less
Signal-to-Noise Ratio	67dB or higher (A-weighted, 20kHz LPF)
Platter	Molded resin
Diameter of Platter	290mm
Tonearm section
Type	Static Balance, Straight
Effective Arm Length	207.9mm
Tracking Force	3.5g
Cartridge section
Type	VM (equivalent to MM)
Output Voltage	3.5mV (1kHz, 5cm/s)
Tracking Force	3.5g ±0.5g
Cartridge Weight	5.0g ±0.3g
Head-shell Weight	10g (including Screws, Nuts and Wires)
Phono Equalizer Amplifier
Type of Amplifier	MM type (On/Thru switchable)
Analog Output
Connector	RCA Pin jack (Gold-plated) × 1 pair
Output Voltage	Phono/Line switchable
Phono Output	2.5mV
Line Output	150mV
General
Power	AC 100-240V, 50/60Hz
Power Consumption	6.0W (less than 0.2W at Standby)
Overall Dimensions (W×H×D)	16.5" × 4.1" × 14.0" 420 × 105 × 355 mm
Weight	Approx. 7-¾ lbs. / 3.5 kg
Accessories	Rubber Mat, EP Adapter, VM-type Cartridge (AT3600L, Pre-installed), Platter, Dust Cover, Hinge × 2, RCA Audio Cable, AC Adapter (GPE053A-120050-Z), Owner's Manual (including Warranty Card for US/Canada)

Model Name	TEAC TN-5BB
Turntable section
Drive system	Rotation-detection-type high-precision control belt drive
Motor	DC motor
Rotation speed	33-⅓rpm, 45rpm, 78prm
Wow and flutter	0.1% or less
Platter	Acrylic, 30cm diameter
Tonearm section
Arm type	Static-balanced S-shaped tone arm
Effective arm length	223mm
Suitable cartridge weight	4.0 to 13.0g (14 to 23 g including head-shell)
Overhang	18mm
Arm height adjustment range	approx. 6mm
Cartridge section
Type	MM
Output voltage	5.5 mV (1kHz, 5cm/s)
Tracking force	1.8g
Cartridge weight	7.2g
Included head-shell weight:	10g (including screws, nuts and wires)
Replacement record stylus model	Ortofon 2M Red • Stylus lifespan depends on use conditions but is usually about 1000 hours.
Phono Outputs
Balanced
Connector	XLR × 1 pair
Unbalanced
Connector	RCA × 1 pair
Power	AC 100 to 240V, 50/60Hz (AC Adapter)
Power Consumption	2.0W or less (0.3W at Standby)
Overall Dimensions (W×H×D)	450 × 148 × 351 mm / 17.1" × 5.8" × 13.8" (with dust cover closed) 450 × 420 × 410 mm / 17.1" × 16.5" × 16.1" (with dust cover open) 450 × 135 × 351 mm / 17.1" × 5.3" × 13.8" (with dust cover removed) Including protrusions (when arm holder at the highest position)
Weight	approx. 10.5kg / 23.2 lbs.
Included accessories	45RPM adapter × 1, Counter Weight × 1, Head-shell (Ortofon 2M Red installed) × 1, Platter × 1, Flat Belt × 1, Pulley Cover × 1, Dust Cover × 1, Hinge × 2, Foot height adjustment washers × 4, Arm height adjustment hex wrench × 1, RCA Audio Cable × 1, Ground wire × 1, AC Adapter (GPE018S-120100-Z) × 1, Cartridge Alignment Gauge × 1, User Manual × 1

Model Name	TEAC TN-4D SE
Turntable section
Type	Direct Drive
Motor	Brush-less DC Motor
Rotation Speeds	33-⅓ rpm, 45 rpm
Wow-and-Flutters	0.1%
S/N Ratio	67dB or higher (A-weighted, 20kHz LPF)
Turntable (Platter)
Material	Aluminium Die-cast
Diameter	30cm
Tone-arm section
Type	S-shaped, Static-balanced
Effective Length	223mm
Needle Pressure Range	0g to 5.0g
Compatible Cartridge Weight	4.0g to 13.0g 14g to 23g (including Head-shell)
Head-shell and Cartridge sections
Type	MM-type (SUMIKO Oyster factory installed)
Output Voltage	4.0mV (1kHz)
Needle Pressure	1.5 to 2.5g (appropriate value: 2.3g)
Weight	5.3g
Head-shell weight	10g (including nuts, screws, and wires)
Compatible Stylus	Styluses for SUMIKO Oyster
Analog Outputs
Connector	RCA Pin jack × 1 pair (PHONO/LINE switchable)
Output Voltage
PHONO	4.0mV (1kHz)
LINE	224mV (–13dBV)
USB Output
Connector	USB B-type (DC 5V 100mA USB Bus power required)
Audio Format	PCM, 8k/11.025k/16k/22.5k/32k/44.1k/48kHz, 16bit
Operating Power	AC 100 to 240V, 50/60Hz
Power Consumption	2W
Standby Power	0.5W or less
Overall Dimensions (W×H×D)	420 × 117 × 356 mm / 16.5" × 4.6" × 14.0"
Weight	Approx. 6.1kg / 13.5 lbs.
Included Accessories	Felt Mat, EP Adapter, Counter Weight, Head-shell (SUMIKO Oyster installed), Platter, Dust Cover, Hinges × 2, RCA Audio cable with GND terminal, AC Adapter (GPE036W-24015), Owner's Manual (including Warranty Card)

Thành Tiền	0đ
Tổng Tiền	0đ

Shopping Cart

TEAC

TEAC TN-550

TEAC TN-570-B

TEAC TN-3B-SE

TEAC TN-400BT-SE

TEAC TN-280BT-A3

TEAC TN-175

TEAC TN-5BB

TEAC TN-4D SE

TEAC TN-180BT-A3